Installation

To install these triggers you should refer to the DYE DSR manual. You will also need to either swap over the trigger bearings, return spring adjustment screw and micro switch activation point screw from your existing trigger or purchase additional parts from DYE. 

DYE recommend running a tap through the adjustment screw threads in the trigger before installing (when I installed my own one of these triggers I cleaned the threads from the stock trigger screws and backed them into the threaded holes in the printed trigger and set their position using blue loctite which worked fine). If you do want to use taps to do this the sizes are 10-32 for the larger hole and 8-32 the smaller one. 

 As the triggers are 3D printed you may also want to ‘fineness’ the part to refine the fit, in my own case I used some super fine wet and dry paper to make any adjustments and the trigger shoots absolutely flawlessly!